Does anyone have the UVA tank dimensions and details of fixings?

better still a fabricator in Essex to make one?

Any recomendation for make of gas mig welder.

thanks

Bob

Hi,
There's a picture of my Fug in the gallery,the fuel tank is not uva but it's there and it's fine. If you think it's ok i'm happy to send you the measurements. I didn't make it,it was already in there when i bought it,can't make you one either as we've no filler necks. Fuel tanks are easy to make and places charge a fortune as they know people will pay it. Personal opinion on welders would be "Clarke" they can be bought cheaply from most plant shops etc. and will do pretty much anything you'd need to on you Fug,steel work anyway.Don't need to spend a fortune on a welder just to do easy tube stuff. I'm also in Essex,where roughly are you?
Bob

100bob

where abouts is the picture posted ?

bob

Hi,
That's a good point,just checked the two postings i've put in the gallery and neither have a picture of my fuel tank :unsure:
I'll post a couple,i'm sure i have some. Are you anywhere near Clacton-on-Sea?

Not so far away outskirts of Southend I beleive he is

Cal

here you go cal - the measurements are as follows:
measurements from a fug 4 maybe the same for a 2 but don't know

Width = 7" (sits on top of the chassis tubes)
length = 22.5"
Height at rear = 15"
Height at front = 11.5"
Distance of filler cap from rear edge = 3" (to centre)
Distance of level gauge from rear edge = 11" (to centre)

The outlet is on the underside, its 5" from the front edge

the return line is at the top, on the side - near the filler cap (see pic)

There appears to be one cantral baffle, its mounted in the same plane as the front and rear panels, it appears to run the height of the tank, but with a few holed to let sensible amounts of fuel through - to prevent major sloshing!

repost from sale area info from Knighty

I must also point out my tank is in my Fug-4......not a fug-2......they might be different, your probably better off designing your own