Can someone do me a favour please??? :(


I've got all the rear end off at the moment because I'm rose jointing everything and swopping the torsion bars for coil overs.....

....the only problem is I've lost the bit of paper which gave me my neutral measurement when i took it all apart :angry:

So...can some kind soul with an IRS / swing axle set up put a tape measure to the centre of the torsion housing cap / spring plate verses the centre of the wheel hub and let me know the distance perferably in mm....and can you also tell me which type you have so I can do the calc's if necessary

many thanks :D